SAM YANG 909 POWER TUNE MODIFICATION PHOTOS

Enlarging the transfer port hole on the air tube for the larger transfer port using a 12mm slot drill
Enlarging the transfer port hole on the air tube for the larger transfer port using a 12mm slot drill
Side view of new bigger transfer port hole
Side view of new bigger transfer port hole
Machining the larger transfer port slot in the receiver cover with 12mm slot drill
Machining the larger transfer port slot in the receiver cover with 12mm slot drill
close up of the enlarges transfer port slot
close up of the enlarges transfer port slot
enlarging the air passage from 6mm to 8mm using the 8mm drill
enlarging the air passage from 6mm to 8mm using the 8mm drill
Enlarging the air passage from 6mm to 8mm using the 8mm drill
Enlarging the air passage from 6mm to 8mm using the 8mm drill
Showing how deep the 8mm drill must go to open up the air passage from 6mm to 8mm
Showing how deep the 8mm drill must go to open up the air passage from 6mm to 8mm

These are the photos of the machine work required to install the Power Tune kit in the Sam Yang 909 Big Bore Airguns

Share this page